Short low profile Exhaust for tillotson 212, Predator 212cc, Honda GX160 GX200

Description

Made in the USA To the highest quality, don't be fooled by the competition that makes everything in China!
the Chinese have copied my products with the worst quality!
... take a moment and look carefully at the quality (the photos speak for themselves)  see the comments of my 100% satisfied clients...
More than 10 years in the
manufacture of these exhausts from Florida USA.
You must know this before you make your purchase!
-
This muffler is a little more Loud than the factory.
-
This exhaust will change color due to the high heat generated by the engine.
-
Muffler can lose paint quickly due to the short distance between the motor and the muffler.
Exhaust does not work on the coleman mini bike, would hit the fender
...
the idea is more for go kart with the frame very tight
.
Please look at all the pictures to know if it will work on your application, compare all the measurements using a measuring tape
to make sure it does not hit the fender or frame.
Type of material:
Mild Steel,
Uncoated Steel.
What includes?
- Exhaust pipe
- Muffler
- 2 Lock washer
- 2 nut
- Gasket
-lock nut for muffler
Engine not included.
Good for:
...
multipurpose.
This been tested on
Predator 212cc (6.5hp) Predator Hemi, Engine From Harbor Freight,
Honda GX160, GX200,
Tillotson Hemi 212 Engine,
XtremepowerUS Electric Start 7 HP,
BILT HARD 7HP 212cc Horizontal Shaft Gas Engine,
AlphaWorks Gas Engine 7HP 212cc,
also tested on Powerhorse 208cc,
DuroMax XP7HPE
(no tested on other engine)
Exhaust pipe Made
in U.S.A.
We only ship to paypal confirmed address.
Florida residents
pay 7
%
taxes.
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry standard for the sizes of pipe is not always as straight-forward as measuring the pipe.
Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is measured and based on the inside of the pipe. But, to actually determine the size of a pipe, the outside diameter of each pipe or fitting must be measured and compared to the table for size identification. For example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches. Each thread size has a defined number of threads per inch (TPI). The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per inch) and OD (outside diameter) of the thread are required for positive identification of thread size because several sizes have the same TPI.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Please check
my other
Header (on other audition)