Hilti DX36 M62 Powder-Actuated Fastening Tool, Fasteners, Load Strips, Accs.

Description

This was listed a few days ago but I ended it until I received clarification about shipping the strip loads.  A flat shipping fee for everything included in the listing has been set to get you the best rate possible and adhere to regulations.
Hilti DX36 M62 Powder-Actuated  Fastening Tool, Case & Instructions
Cleaning Brushes (3)
Hilti DX-36M Shear Clips (3)
Rubber Stabilizer
Hilti Spray Lubricant - Not  included; See Notes  below
Includes over 1100 Fasteners(see photos)
listed below:
Masterset Fasteners to fit Hilti  Tools
#27 - 369 pcs,   8mm head x 1" length
#19K - 359 pcs,  8mm head x 5/8" length knurled
#22 - 100 pcs,  8mm head x 3/4" length
#52 - 173 pcs,  8mm head x 2" length
#62 - 100 pcs 8mm head x 2 1/2" length
Partial box of Hilti Brand  Fasteners #62 - 33 pcs 8mm head x 2 1/2" length
Includes about a"1000" 27 caliber strip loads (see photos & list below)
:
33 strips x 10 - Masterset 27SL3 Green Power Level (330)
28 strips x 10 - Masterset 27SL4 Yellow Power Level (280)
56 strips x 10 - Hilti  #5 Red  Power Level (560) - This was the highest power load; normally too high.
The load strips  may no longer  fire. Even when they were new some of them would not fire.
Use at your own risk
TIP
:  The fasteners  need just enough power to set them fully. There is an adjustment screw above   the handle that allows fine tuning when you are doing repetitive shots. If all  the way down is too rough (too much power) then go to softer load (lower power).
TIP:
The Hilti Spray in the  picture would no longer spray. It also left a sticky residue as it drys which in turn catches ash from the shots.  I cleaned the gun today with  BreakFree gun lube/cleaner but there is still evidence of the ash build up inspots. If you clean upon arrival the BreakFree may have loosened the ash sot  hat it easily wipes off.
I bought this new and it was always functioned well.  The gun was cleaned before listing and seems to work normally.  I did forget to shoot it before I cleaned it.  But upon buyers request I will still shoot it before shipping if you desire, but won't clean again.