Center Rear Exhaust with Muffler for: Predator 3HP 79cc from Harbor Freight Tool

Description

You must know this before you make your purchase!
-
There is no painting in this exhaust,
Rust can come out over time,
"solution" you
applies high heat paint.
-
The chrome of the Muffler will peel it in 5mins...
if you don't agree with this ...don't buy it!
-
This muffler is a little more Loud than the factory.
-
The muffler has a 1/2 NPT thread,
it is not possible to put it until the end, you will have 1/4 of thread outside which is normal.
-
This exhaust will change color due to the high heat generated by the engine.
ONLY FOR THE PREDATOR 79CC FROM HARBOR FREIGHT TOOLS, DOES NOT WORK IN ANY OTHER NO MATTER IF YOUR ENGINE HAS THE SAME CC.
Please! look at all the pictures to know if it will work on your application, compare all the measurements using a measuring tape
to make sure it does not hit the fender or frame.
- Exhaust with Muffler!
- 2 Lock washer and 2 nut included.
*Gasket & Engine not included.
Exhaust pipe Made
in U.S.A.
We only ship to paypal confirmed address.
Florida residents
pay 7
%
taxes.
-------------
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry standard for the sizes of pipe is not always as straight-forward as measuring the pipe.
Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is measured and based on the inside of the pipe. But, to actually determine the size of a pipe, the outside diameter of each pipe or fitting must be measured and compared to the table for size identification. For example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches. Each thread size has a defined number of threads per inch (TPI). The 3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per inch) and OD (outside diameter) of the thread are required for positive identification of thread size because several sizes have the same TPI.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------
Please check
my other
Header (on other audition)